14 | Section 2
Main page - General Conguration
Engine Name. Assigns the text name for this VX Engine. It becomes the Linux network name
for the Engine.
If you will not use the defaults for IP, Netmask, and Gateway, enter them here. IP addresses
can be entered for both the LAN and WAN ports.
Web Username and Password. Used for web access for configuration and monitoring. User-
name is always ‘user’ and the default password is <blank>.
LWCP Password. LWCP stands for Livewire Control Protocol, the way controllers communicate
with the VX Engine. A password can be used to secure the Engine from being controlled by
unauthorized devices. The VXset, for example, uses this password. By default, this is set to
<blank>.
To Next Page
Loading...