EasyManua.ls Logo

Telos VX - Specifications; System; Audio Performance

Telos VX
111 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
62 | Section 5
Specications
System
Maximum number of phone lines: 48, when used with aLaw or uLaw codecs for VoIP lines.
(Higher quailty codecs, such as G.722, consume more system resources and result in a de-
creased number of total lines available.)
Maximum number of SIP numbers: 250
Maximum active on-air calls: 30
Number of hybrids: one per each active line
Maximum number of studios: 20
Maxiumum number of Livewire input/output channels - 20 systemwide
Audio performance
Analog Line Inputs
♦ Input Impedance: >40 k ohms, balanced
♦ Nominal Level Range: Selectable, +4 dBu or -10dBv
♦ Input Headroom: 20 dB above nominal input
Analog Line Outputs
♦ Output Source Impedance: <50 ohms balanced
♦ Output Load Impedance: 600 ohms, minimum
♦ Nominal Output Level: +4 dBu
♦ Maximum Output Level: +24 dBu
Digital Audio Inputs and Outputs
♦ Reference Level: +4 dBu (-20 dB FSD)
♦ Impedance: 110 Ohm, balanced (XLR)
♦ Signal Format: AES-3 (AES/EBU)
♦ AES-3 Input Compliance: 24-bit with selectable sample rate conversion, 32 kHz to 96kHz
input sample rate capable.
♦ AES-3 Output Compliance: 24-bit
♦ Digital Reference: Internal (network timebase) or external reference 48 kHz, +/- 2 ppm
♦ Internal Sampling Rate: 48 kHz
♦ Output Sample Rate: 44.1 kHz or 48 kHz
♦ A/D Conversions: 24-bit, Delta-Sigma, 256x oversampling
♦ D/A Conversions: 24-bit, Delta-Sigma, 256x oversampling
♦ Latency <3 ms, mic in to monitor out, including network and processor loop

Table of Contents