NOTES, RESOURCES, ADDITIONAL INFORMATION | 87
In our example here, we only use Vitelity for incoming calls, so the ‘Outgoing Dial Rules’ are
irrelevant. We could insert a period in the Dial Rules box that would simply pass whatever
digits were dialed down the trunk to Vitelity. Keep in mind that this is just the trunk setup, and
that there still has to be inbound and outbound routes to get calls into and out of the switch.
For incoming calls, this is done with an inbound route that matches digits sent be the provider,
the Direct Inward Dial number itself and telling it “where to go”, in our case, to an extension.
To Next Page
Loading...