Tenda AC1200 - Ports and Buttons

3
1.3 Ports and buttons
Port/Button
Description
ON/OFF
It is used to power on or power off the router.
PWR
Power jack.
It is used to connect to the included power adapter.
RST/WPS
It serves as both reset and WPS button.

Press the button and release it, the (Wi-Fi) indicator blinks. The router gets
ready for WPS negotiation. Configure WPS-enabled wireless devices within 2
minutes to start WPS negotiation with the router.

When the router is working properly, hold down the button for about 8 seconds
and release it when all indicators light off and then light up. The router is restored
to factory settings.
WAN/LAN
It is a gigabit Ethernet port, which can serve as a WAN port or a LAN port. By default,
it is a LAN port.

When the router is under 3G/4G router mode, it serves as a LAN port.

When the router is under wireless router mode, it serves as a WAN port.

When the wireless repeating function is enabled, do not connect any device to this
port.

When the AP mode is enabled, it serves as a LAN port.
LAN
It is a LAN port used to be connected to wired devices, such as a computer.
When the IPTV function is enabled under the wireless router mode, it serves as the
IPTV port to be connected to the set top box.