54
5.5 Transmit power
In this module, you can adjust the wall-penetration capability and wireless coverage of the router
by setting the transmit power.
To access the configuration page, log in to the web UI of the router, and choose Wi-Fi Settings >
Transmit Power.
It specifies the mode of signal strength. The default mode is High.
High: It is typically used to meet wireless coverage requirements in large or multi-barrier
environments.
Medium: It is typically used to meet wireless coverage requirements in medium-area or
less-obstacle environments.
Low: It is typically used to meet wireless coverage requirements in small area or barrier-
free environments.
It is recommended to choose the Low mode if the network experience is satisfactory
enough under this mode.
To Next Page
Loading...
