Tenda AC1200 - Wireless Repeating

41
5.3 Wireless repeating
This function is only available under the wireless router mode. Refer to Operating mode to set the
operating mode of the router.
5.3.1 Overview
By configuring the wireless repeating function, you can extend the coverage of the existing Wi-Fi
network.
To access the configuration page, log in to the web UI of the router, and choose Wi-Fi Settings >
Wireless Repeating.
This function is disabled by default. When it is enabled, the page is shown as below.

When the wireless repeating function is enabled, some other functions will be unavailable, such
as Wi-Fi schedule, guest network, WPS and IPTV.

When wireless repeating is enabled, do not connect any device to the WAN port of the router.
Parameter description
Parameter
Description
Wireless Repeating
It is used to enable/disable the Wireless Repeating function.
Repeating Mode
Two repeating modes are available:

WISP mode: Generally used to bridge the hotspot of ISPs.

Client+AP mode: Able to bridge all kinds of Wi-Fi network.

When WISP mode is chosen and the LAN IP of the router is at the same network
segment as that of the upstream device, the router will change the LAN IP address to
a different network segment to avoid conflict.

After the router is set to WISP mode, you are required to access the internet by