EasyManuals Logo

Tenda AC1200 User Manual

Tenda AC1200
207 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
165
12.3 WAN settings (wireless router mode)
This function is only available under the wireless router mode. Refer to Operating mode to set the
operating mode of the router.
In the WAN Parameters module, you can check and modify MTU value, WAN speed, duplex mode,
MAC address, service name and server name.
12.3.1 Change MTU value
MTU (Maximum Transmission Unit) is the largest data packet transmitted by a network device.
When the connection type is PPPoE, the default MTU value is 1480. When the connection type is
dynamic IP address or static IP address, the default MTU value is 1500. Do not change the value
unless necessary. If you need to, please refer to the following instructions.
To access the configuration page, log in to the web UI of the router, and choose System Settings >
WAN Settings.
Generally, the default value is recommended. Try to change the MTU value when:
You cannot access some specific websites or encrypted websites (such as E-banking
or Paypal websites).
You cannot receive and send Emails or access a FTP or POP server.
You can try reducing the value of MTU gradually from 1500 until the problem is resolved (The
recommended range is 1400 to 1500).
MTU application description
MTU
Application
1500
It is commonly used for non-ADSL and non-VPN dial-up connections.

Table of Contents

Other manuals for Tenda AC1200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tenda AC1200 and is the answer not in the manual?

Tenda AC1200 Specifications

General IconGeneral
Data Transfer Rate1200Mbps
Wireless StandardIEEE 802.11ac/a/n 5GHz, IEEE 802.11b/g/n 2.4GHz
Frequency Bands2.4GHz, 5GHz
Wireless Speed300Mbps (2.4GHz) + 867Mbps (5GHz)
Antenna4 x 5dBi external antennas
SecurityWPA/WPA2-PSK
ButtonWPS button, Reset button
DHCP ServerSupport

Related product manuals