47
If you cannot access the internet, try the following solutions:
Ensure that the existing router is connected to the internet successfully.
Ensure that your wireless devices are connected to the correct Wi-Fi network of the new router.
If the computer connected to the router for repeating cannot access the internet, ensure that the
computer is configured to obtain an IP address and DNS sever automatically.
Method 2: Set the new router to Client+AP mode
Configuring procedure:
Step 1 Log in to the web UI of the router.
1. Put the new router near the existing router and power it on. Connect your wireless device
to the Wi-Fi network of your new router, or connect a computer to the LAN port of the
router. Do not connect any device to the WAN port of the new router.
2. Start a web browser on a device connected to the router and visit tendawifi.com to log in
to the web UI of the router. A computer is used for illustration below.
If you have finished the quick setup wizard before, skip to Step 2 to proceed with the configuration.
3. Click Start.
To Next Page
Loading...
