4
1.2.2 Appearance of O3
LED Indicators
O3
The device is being powered properly, and no data is being transmitted.
Data is being transmitted over the port.
The device is not powered on.
LED1, LED2, LED3
(Signal Strength LED)
The device has wireless clients connected to it and may work in AP,
Repeater, or Router mode. If you performed auto bridging, the device is
already set to AP mode.
LED1, LED2 and LED3 are solid on: Perfect Signal
LED1 and LED2 are sold on, and LED3 is off: Good signal
LED1 is solid on, and LED2 and LED3 are off: Weak signal. Please adjust
the direction or location of the two devices.
The device is working in Client, Universal Repeater or WISP mode, and
connected to a remote AP. If the device is automatically connected to the
other one, it is set to Client mode.
The device is not connected to a wireless client or a remote AP.
To Next Page
Loading...
Need help?
General
