158
Appendix
A.1 FAQ
Q1: I cannot log in to the web UI of the device by entering 192.168.2.1. What should I do?
A1: Try the following methods and try again:
− Ensure that the device has been connected to the power supply and the computer properly.
− Ensure that the IP address of the login computer is 192.168.2.X (X ranges from 2 to 254).
− Reset the device to factory settings.
Q2: How to reset the device to factory settings?
A2: Note: Resetting the device will clear all settings, and you need to configure it again.
Method One: 1 minute after the device is powered on, uncover the device, and hold down the reset button
for about 8 seconds.
Method Two: Log in to the web UI of the device, choose Tools > Maintenance, and click the Reset button.
Q3: How to judge whether the bridging signal is optimal when the devices are used for CCTV surveillance?
A3:
Method One: Observe the LED indicators of the two devices. The bridging signal is optimum when the LED1,
LED2 and LED3 indicators are solid on or flashing.
Method Two: Log in to the web UI of one device (default login address: 192.168.2.1), choose Status, and
check the wireless status on the following page:
To Next Page
Loading...
Need help?
General
