73
6.3 DHCP Server
6.3.1 Overview
The CPE provides a DHCP server function to assign IP addresses to clients on the LAN. By default, the DHCP
server function is disabled.
If the new and original IP addresses of the LAN port belong to different network segment, the system
changes the IP address pool of the DHCP server function of the CPE so that the IP address pool and the
new IP address of the LAN port belong to the same network segment.
6.3.2 Configuring the DHCP Server
Step 1 Choose Network > DHCP Server to enter the configuration page.
Step 2 Enable the DHCP server.
Step 3 Set the parameters. Generally, you need to set only Gateway Address and Primary DNS Server.
Step 4 Click Save.
----End
If another DHCP server is available on your LAN, ensure that the IP address pool of the CPE does not
overlap the IP address pool of that DHCP server. Otherwise, IP address conflicts may occur.
To Next Page
Loading...
Need help?
General
