144
Parameters Description
It specifies whether to enable the Ping Watch Dog function.
It specifies the target IP address that the device pings.
It specifies the interval at which the device transmits packets to ping the target IP address.
It specifies the interval at which the device enables the Ping Watch Dog function after the device
reboots.
You can set this parameter to keep the device from rebooting repeatedly on account that the
system triggers Ping Watch Dog during rebooting while users cannot log in to the web UI of the
device to change the settings.
Threshold of Lost Packets
It specifies the threshold of lost packet that triggers reboot. Range: 1 to 65535, default: 3.
If N is set, the device will reboot automatically when it sends N Ping packets to target IP
address/domain name, and does not receive response.
8.6.7 DMZ Host
This function is available only when the CPE works in WISP or Router mode.
Overview
A DMZ host on a LAN can communicate with the internet without limit. You can set a computer that require
higher internet connection throughput, such as a computer used for video conferencing or online gaming, as a
DMZ host for better user experience.
A computer set to DMZ host is not protected by the firewall of the CPE.
A hacker may leverage the DMZ host to attack your LAN. Therefore, enable the DMZ function only when necessary.
Configuring DMZ Host
Configuration Procedure
Step 1 Choose Advanced > Network Service.
Step 2 Enable the DMZ Host function.
Step 3 Enter the IP address of the device to be set to DMZ host.
Step 4 Click Save on the bottom of this page.
To Next Page
Loading...
Need help?
General
