152
Configuration Procedure
Step 1 Download the package of a later firmware version for the CPE from http://www.tendacn.com to your
local computer, and decompress the package.
Step 2 Log in to the web UI of the CPE and choose Tools > Maintenance.
Step 3 Click Upgrade.
Step 4 Select the file from your local computer for upgrading the firmware.
----End
A progress bar is displayed on the page. Wait for it to elapse. Then Log in to the web UI of the CPE, and check the
Firmware Version on the Status page, and ensure that the version displayed here is the same as the firmware
you upgrade.
After the firmware is upgraded, you are recommended to restore the factory settings of the CPE and
configure the CPE again, so as to ensure stability of the CPE and proper operation of new functions.
9.2.4 Backup/Restore
The backup function enables you to back up the current configuration of the CPE to a local computer. The
restoration function enables you to restore the CPE to a previous configuration.
If the CPE enters the optimum condition after you greatly change the configuration of the CPE, you are
recommended to back up the new configuration, so that you can restore it after upgrading or resetting the CPE.
If you need to apply same or similar configurations to many CPEs, you can configure one of the CPEs,
back up the configuration of the CPE, and use the backup to restore the configuration on the other
CPEs. This improves configuration efficiency.
To Next Page
Loading...
Need help?
General
