109
7.3 Access Control
7.3.1 Overview
It specifies, based on MAC address filter rules, the wireless devices that can or cannot access the wireless
networks of the CPE. The CPE supports the following MAC address filter rules:
− Disallow: It indicates that only the wireless devices with the specified MAC addresses cannot access
the wireless networks of the CPE.
− Allow: It indicates that only the wireless devices with the specified MAC addresses can access the
wireless networks of the CPE.
7.3.2 Configuring Access Control
Configuration Procedure
Step 1 Choose Wireless > Access Control.
Step 2 Enable the Access Control function.
Step 3 Select a MAC address filter mode, Disallow or Allow.
Step 4 Enter the MAC addresses to control in the access control list and click Add.
If the wireless devices to be controlled are connected to the CPE, directly click Add online devices to
add them to the access control list quickly.
Step 5 Click Save.
----End
To Next Page
Loading...
Need help?
General
