The wireless function is enabled, but no data is being transmitted.
Data is being transmitted in a wireless manner.
The wireless function is disabled.
LED1, LED2, LED3
(Signal Strength LED)
Bridged successfully, and the device works in AP mode.
LED1, LED2 and LED3 are solid on: Perfect Signal
LED1 and LED2 are sold on, and LED3 is off: Good signal
LED1 is solid on, and LED2 and LED3 are off: Weak signal. Please adjust the
direction or location of the two devices.
Bridged successfully, and the device works in Client mode.
The device does not bridge to another peer AP.
Power Jack
Connect the included power adapter to this jack to supply power to the device.
Reset Button
After the device is powered on for 1 minute, hold down this button for about 7 seconds.
When all the LED indicators on the device light up, the device is restored factory settings.
To Next Page
Loading...
Need help?
General
