5 Status
This module allows you to view the information of system and wireless network.
5.1 System Status
Log in to the web UI of the CPE, and choose Status. You can view the system status here.
If the CPE is set to AP mode, Client mode, Universal Repeater mode, Repeater mode or P2MP mode, the
system status is shown as follows:
Parameters Description
It specifies the name of this device. If this device is not the only one of its kind in the network,
this name helps you identify the device. You can change the name of this device on the
Network > LAN Setup page.
It specifies time during which this device is operating.
It specifies the current system time of this device.
It specifies the system software version number of this device.
It specifies the hardware version of this device.
It specifies the MAC address of LAN port of this device. When connecting to another device
using an Ethernet cable, the CPE uses this MAC address to communicate with the device.
To Next Page
Loading...
Need help?
General
