74
Parameters Description
It specifies whether to enable the DHCP server function of the CPE. By default, it is disabled.
It specifies the start IP address of the IP address pool of the DHCP server. The default value is
192.168.2.100.
It specifies the end IP address of the IP address pool of the DHCP server. The default value is
192.168.2.200.
The start and end IP addresses must belong to the same network segment as the IP address of
the LAN port of the CPE.
It specifies the validity period of an IP address assigned by the DHCP server to a client.
When half of the lease time has elapsed, the client sends a DHCP Request to the DHCP server to
renew the lease time. If the request succeeds, the lease time is extended according to the
request. Otherwise, the client sends the request again when 7/8 of the lease time has elapsed.
If the request succeeds, the lease time is extended according to the request. Otherwise, the
client must request an IP address from the DHCP server after the lease time expires.
It is recommended that you retain the default value 1 day.
It specifies the subnet mask assigned by the DHCP server to clients. The default value is
255.255.255.0.
It specifies the default IP address gateway assigned by the DHCP server to clients. Generally, it
is the IP address of the LAN port of a router on the LAN. The default value is 192.168.2.254.
A client can access a server or host not in the local network segment only through a gateway.
It specifies the primary DNS server IP address assigned by the DHCP server to clients. The
default value is 8.8.8.8.
To enable clients to access the internet, set this parameter to a correct DNS server IP address or
DNS proxy IP address.
It specifies the secondary DNS server IP address assigned by the DHCP server to clients. This
parameter is optional.
To Next Page
Loading...
Need help?
General
