159
Stronger signal strength (-90 is better than -100) and less background noise (-100 is better than -90)
indicates better bridging signal.
Q4: After the installation succeeds, the monitors connected to the NVR cannot display the surveillance videos.
What should I do?
A4: Try the following solutions:
− Ensure that all devices are working normally, and connected properly.
− Refer to the following figure to find the problem. Ensure that the IP addresses of computer, NVR,
and IP cameras are in the same network segment.
− If the preceding check is normal, it indicates the connections are properly. Please check the
configuration information, including the configuration information of NVR, and IP cameras.
To Next Page
Loading...
Need help?
General
