Tenda PON ONT HG9 - Page 76

Services
66
Parameter description
Parameter
Description
FilterDirection
It specifies the forwarding direction of data to be filtered.
Direction (HG6)
Default Action
It specifies the default action for the outgoing(LAN WAN) or incoming(WAN LAN)
data.
⚫
Deny: Denies traffic which does not match the filter rule in the Current Filter Table.
⚫
Allow: Allows traffic which does not match the filter rule in the Current Filter Table.
Protocol
It specifies the protocol adopted by data to be filtered.
⚫
TCP: TCP protocol.
⚫
UDP: UDP protocol.
⚫
ICMP: ICMP protocol.
⚫
TCP/UDP: TCP protocol and UDP protocol.
⚫
ANY: Any protocol.
Rule Action
It specifies whether to deny or allow the data to pass through.
⚫
Deny: Packets that comply with the rule are denied, while others are perform the
default action.
⚫
Allow: Only packets that comply with the rule are allowed, while others are perform
the default action.
Source IP Address
It specifies the source IP address of the packets. The settings of Source IP Address and
Subnet Mask determine which computers are affected by this rule.
⚫
When Filtering Direction is set to LAN WAN, this parameter specifies the LAN
computer’s IP address to be affected.
⚫
When Filtering Direction is set to WAN LAN, this parameter specifies the internet
computer’s IP address to be affected.
⚫
When this parameter is left blank, all IP addresses are covered.
Subnet Mask
It specifies the subnet mask of the source IP address.