Tenda PON ONT HG9 - Page 78

Services
68
Parameter description
Parameter
Description
MAC Filtering
It specifies whether to enable the MAC filtering function.
Mode
It specifies the mode of the MAC filtering function.
⚫
Whitelist: Only data packets whose source or destination MAC addresses are
added in the current filter table can access the internet.
⚫
Blacklist: Data packets from the LAN whose source or destination MAC addresses
are added in the current filter table cannot pass through the ONT.
Source MAC Address
They specify the source and destination MAC addresses of data packets.
You can only enter one source MAC address and destination MAC address in one
MAC filtering rule.
The MAC address cannot contain any special characters. An example in the correct
format is cc3a61711b6e.
Destination MAC
Address
Allow only specified devices to access the internet
Scenario: The Wi-Fi network at your home is misused by unknown users sometimes.
Goal: Only allow certain devices of family members to access the internet.
Solution: You can configure the MAC address filter function to reach the goal.
Assume that:
Device
MAC address
Status
Your own phone
8C:EC:4B:B3:04:93
Connected
Family member's phone 1
94:C6:91:29:C2:12
Disconnected
Family member's phone 2
98:9C:57:19:D0:1B
Disconnected
Configuring procedure:
Step 1 Log in to the web UI of the ONT.
Step 2 Choose Services > Firewall > MAC Filtering.
Step 3 Set MAC Filtering to Enable, and click Apply Changes.
Step 4 Set Mode to Whitelist, and click Apply Changes.
Step 5 Enter 8CEC4BB30493 in the Source MAC Address field, and click Add.
Step 6 Repeat Step 5 to add the other two MAC addresses.