User Guide
165
1. Select an ACL
2. Click Add Rule. Configure required settings and click OK.
Fields on the screen are described below:
Select an existing ACL and specify rules for it.
Specify a priority for a given rule, which determines
match scheduling order.
If an ACL has multiple rules, the rule with smallest
priority value will be first scheduled for match
purpose.
Specify the VLAN ID of the messages for ACL rules
to apply.
Specify source MAC and destination MAC of
packets for a rule to match.
Note: If Any is selected, the rule will match and
apply to all packets with whatever source
MAC/destination MAC.
Specify the message type in Hex.
Permit: Allow messages that match existing rules
to pass.
Prohibit: Discard messages that match existing
rules.
Rate Limit: Limit forwarding rate of messages
that match existing rules (64-1048576kbps).
The default action is Prohibit.
Select time range ID for rule application. Within the
set time range, rules will take effect. By default, no
time range is specified and ACL rules take effect at
any time.
To Next Page
Loading...
