User Guide
167
Select an ACL from the ACL drop-down list and click Add Rule to enter the corresponding interface.
Specify a rule for the ACL and click OK.
Fields on the screen are described below:
Select an existing ACL and specify rules for it.
Specify a priority for a given rule, which determines
match scheduling order. If an ACL has multiple
rules, the rule with the smallest priority value will be
first scheduled for match purpose.
Select a protocol to match.
Specify source IP and destination IP of packets for a
rule to match.
Note: If Any is selected, the rule will match and
apply to all packets with whatever source
IP/destination IP.
Specify source port number to match TCP/UDP
messages.
Note: If Any is selected, the rule will match and
apply to any source port.
Source port is configurable only when TCP or UDP
protocol is selected.
Specify destination port number to match TCP/UDP
messages.
Note: If Any is selected, the rule will match and
apply to any destination port.
Destination port is configurable only when TCP or
UDP protocol is selected.
Specify an action to handle messages:
Permit: Allow messages that match existing rules to
pass.
Prohibit: Discard messages that match existing
rules.
Rate Limit: Limit forwarding rate of messages that
To Next Page
Loading...
