User Guide
181
Fields on the screen are described below:
Configure global 802.1X status
Enable: Enable 802.1X feature globally.
Disable: Disable 802.1X feature globally.
By default, the 802.1X feature is disabled
globally on the device.
Note: 802.1X settings take effect only when
the 802.1X feature is enabled on both the
device and specific ports.
Server IP Address
Authentication
Specify a valid Authentication Server IP that is
on the same net segment as the switch's
management IP address.
Enter the authorized shared key as it is on the
Radius authentication/authorization server.
Enable or disable re-authentication on all
ports.
Recertification
Time-out Timer
Specify an interval for device to initiate an
802.1X re-authentication.
This timer is started while the switch sends
Request/Challenge request to a targeted
client. If no response is received from the
client within the set time length, switch will
resend the request.
802.1X Port Setup
Click Security -> 802.1X -> 802.1X Port Setup to enter interface below:
To Next Page
Loading...
Need help?
General
