User Guide
207
Note: Delete domain name settings and restore to default factory settings (MAC address of the
device)
TENDA(config-mst)# revision 52
Note: Delete revision level settings and restore it to the default 0.
TENDA(config-mst)# no instance 3
Note: Delete this instance’s vlan mapping and disable this instance
STP Port configuration
TENDA(config)# interface range gigabitethernet 0/1-4
Note: Enter the directory of ports 1-4
TENDA(config-if)# spanning-tree
Note: Enable STP
TENDA(config-if)# no spanning-tree
Note: Disable STP
TENDA(config-if)# spanning-tree autoedge
Note: Set corresponding port(s) to edge port(s).
TENDA(config-if)# no spanning-tree autoedge
Note: Set corresponding port(s) to non-edge port(s).
TENDA(config-if)# spanning-tree link-type point-to-point auto
Note: spanning-tree link-type point-to-point auto
TENDA(config-if)# spanning-tree link-type point-to-point force-false
Note: Set port as non-p2p port
TENDA(config-if)# spanning-tree link-type point-to-point force-true
Note: Set port as p2p port
TENDA(config-if)# no spanning-tree link-type point-to-point
Note: Delete current p2p port setting and restore it to factory default
TENDA(config-if)# spanning-tree mstp 10（0-15） cost default
Note: Set path cost to 802.1t auto mode in the instance
TENDA(config-if)# spanning-tree mstp 0 cost 2000
Note: Set port path cost to 2000
TENDA(config-if)# spanning-tree mstp 2 port-priority 96
Note: Set port priority to 96
To Next Page
Loading...
Need help?
General
