User Guide
50
3. If the MAC address of a Host is classified into 802.1Q VLAN, please set its connected port of the switch
to be a member of this 802.1Q VLAN so as to ensure the packets are forwarded normally.
MAC VLAN---Config
MAC VLAN can only be valid in 802.1Q VLAN mode. Click VLAN Management -> MAC VLAN to enter
interface below:
Create MAC VLAN
1. Click New to enter interface below:
2. Enter the MAC address you wish to configure.
3. Enter the corresponding MAC address description.
4. Select this MAC VLAN's priority (0~7 available) from the drop-down list.
5. Configure the VLAN ID mapped from MAC address. This VLAN ID must already exist in 802.1Q
VLAN.
6. Click OK.
Delete MAC VLAN
As shown above, click the Delete button to delete the corresponding MAC VLAN. Up to 64 MAC VLANs
can be supported on this device.
To Next Page
Loading...
