2-1 TA9 & TA10 Dumper 0803-3 Devcember 2010
Introduction
Introduction
TEREX appreciates your choice of our product for your
application. Our number one priority is user safety which is best
achieved by our joint efforts. We feel you can make a major
contribution to safety if, you as the machines user:
• Comply with all the relevant National Laws and Local
Regulations.
• Read, Understand and Follow the instructions in this and
any other manuals supplied with this machine.
• Use Good, Safe Work Practices in a common sense way.
• Only Use Trained Operators to operate the machine who
are directed by informed and knowledgeable supervision.
If there is anything in this manual which is not clear or there is
information which you think should be added, contact the
Manufacturers Service Department who will deal with your
problem or request.
We reserve the right to make improvements to these machines
without incurring any need to change these operating
instructions.
Any modification to this machine which has not been approved
by the Manufacturer in writing immediately invalidates the
Manufacturers warranty.
Safety Alert System
Intended Use
The machine has been designed and tested to carry out the
function of transporting various free flowing materials. If used
correctly, it will provide an effective means of transportation
and meet the appropriate performance standards and
regulations.
Use of this product in any other way is prohibited and contrary
to its intended use.
Instruction Manual
Read this instruction manual carefully before operating the
machine. Ensure this instruction manual is kept with the
machine at all times and is in good condition - replace the
manual immediately if it becomes dirty, damaged or has been
lost. The manual holder for this manual is located behind the
seat.
The Safety Alert Symbol is used to alert you
to potential personal injury hazards. Obey all
safety messages that follow this symbol to
avoid possible injury or death.
Machine LEFT and RIGHT HAND
All references in this manual to LEFT and RIGHT
are as viewed from the Operating Position
(Operators Seat) with Operator facing the skip.
To Next Page
Loading...
Need help?
General
