Terex TA10 User Manual

Operating Instructions
TA9 & TA10 Dumper 0803-3 December 2010 7-8
Starting and Stopping the Engine
Starting the Engine
Before attempting to start the engine ensure:-
• There are no obvious faults with the machine.
• The Operator is Sitting on the Operators Seat.
• The handbrake is applied and Forward/Reverse switch (A) is
in neutral (0) and ALL warning lights on the dashboard are
illuminated when the start key (B) is turned to the RUN
position (1).
• Turn the start key (B) to the HEAT position (2) and hold for
10 seconds.
• Turn the start key switch (B) to the START position (3),
release immediately the engine starts and allow the key to
return to the RUN position (1).
• When engine has started, ensure ALL warning lights on the
dashboard are no longer illuminated except the handbrake
‘ON’ light. If any are still illuminated stop the engine and
have the fault rectified before using the dumper.
Stopping the Engine
• Before stopping the engine the machine must be on firm,
level, stable ground, it must not be in a dangerous position or
causing an obstruction to others, the handbrake must be
applied and the forward / reverse switch (A) and gear lever
should be in neutral.
• The engine is stopped, in normal use, by the Operator
turning the start switch (B) anticlockwise to the OFF
position (0).
Do Not Use Starting Sprays to Assist Engine Starting
Do Not Crank Engines for More than 10 Seconds
- Allow 30 Second Delay Before Further Starting Attempt
NOTICE
Never Engage the Starter Motor Whilst Engine is Running
0515-053c
A
0
NOTICE
Allow the engine to ‘idle’ for 30 seconds before stopping
engine especially if the engine has been ‘worked hard’
b
If leaving the machine unattended, remove the start key
and turn the battery isolator to the OFF position and
remove the isolator key. This will help prevent the
machine from being used by unauthorised people.
0
1
2
3
B
0515-074a

Terex TA10 Specifications

General

Brand	Terex
Model	TA10
Category	Mini Skid Steers
Language	English