Maintenance
TA9 & TA10 Dumper 0803-3 December 2010 9-8
Engine Oil
Always use the Engine Manufacturers Handbook for
instructions when checking or servicing the engine, e.g. oil
level, filters, fan belt etc.
If this is not available the following procedures should be
followed for checking and changing the engine oil.
Engine Oil Level Checking
• Park the machine on firm, level ground.
• Stop the engine and let the machine stand for a few minutes
to allow the oil to drain into the engine sump.
• Remove engine dipstick (A), located behind the oil filter,
wipe clean with paper, replace the dipstick. Remove and
check the oil level on dipstick.
• If the oil level is below the MIN level (E), remove the engine
oil filler cap (C) and add clean, fresh oil of the correct grade
to the engine. While adding oil, check the level frequently to
ensure it does not go over the MAX level (D). Replace the
filler cap (C).
b
The Dumper MUST be On Firm Level Ground when
Checking or Changing the Oil
To Next Page
Loading...
Need help?
General
