TL260
Maintenance
108 / 187
6
06_Maintenance_en.fm - V 0.1 - 14.4.11
11
6.8 Taking out of service
6.8.1 Preservation (temporary immobilization )
Preserving the machine
We recommend keeping the machine in a dry, dust-free room during the
storage period.
Thoroughly clean the inside and outside of the machine, including the engine.
Lubricate the machine by following the lubrication plan. See chapter 6.5.1
"Lubrication plan", page 58.
Check and top up all oil levels in components like engine, gearbox, etc.
Check and top up the hydraulic oil level.
Repair paint damage.
Fill the diesel fuel tank completely to avoid wall corrosion.
Check the antifreeze properties of the coolant and adapt these, if necessary.
Apply all preservation measures as specified in the operating instructions for
the engine.
Check the tire pressure according to the prescribed value and protect the
tires from direct sunlight.
Treat bare piston rods with a commercially available corrosion protection
agent.
Remove the battery, clean it and store it properly in a dry and, over winter, in
a frost-free room. Cover the poles with pole grease.
Close the air intake openings of the air filter system and the exhaust outlet on
the exhaust pipe.
Check whether there are special procedures from CUMMINS.
Property damage
Machine damage caused by
bearing defects (e. g. corrosion
damage) during shutdown
periods over three months.
Z Preserve the machine.
To Next Page
Loading...
