TL260
Maintenance
06_Maintenance_en.fm - V 0.1 - 14.4.11
61 / 187
6
11
Tab. 6-9 Daily tasks
6.6.2 Tasks to be performed weekly
Control and maintenance work to be performed by the operating personnel
(filling, cleaning, repairing, replacing if necessary):
Tab. 6-10 Tasks to be performed weekly
Item Inspection See
1 Check the hydraulic oil level P. 87
2 Check the engine oil level P. 67
3 Check fuel level (fuel gauge in control console) P. 81
4 Check windshield washer fluid level
5 Visual inspection (general), e. g. for material cracks, external damage, completeness, etc.
6 Check whether there is water and/or dirt in the fuel line of the water separator and clean
if necessary.
P. 85
7 Check for leaks in pipes, hoses, control unit, hydraulic pumps, cylinders, etc.
The screw-in couplings must be locked when tightening hose or line connections
to prevent rotation.
8 Check function of electrical indicating and warning elements as well as the lighting system P. 104
9 Check smooth movement of operating controls
10 Check V-belt tension
Item Inspection See
11 Drain the fuel filter
12 Check the cooling fins of the combined cooler
Machine damage due to strong accumulation of dust
Clean the combined cooler by hand
P. 73
13 Check correct function of door catches
14 Check tire pressure and tightness of wheel nuts
15 Check fastening of axles and propeller shaft
16 Check bearing bushings and pins/bolts of work equipment
17 Check pins/bolts, bushings, and the linkage assembly of the articulated steering
18 Check that pneumatic springs of engine hood function perfectly
19 Check function of brakes
20 Check if the dust filter for cab ventilation is dirty and clean if required
Machine damage due to strong accumulation of dust
Shorten the inspection and cleaning intervals
21 Check function, condition and completeness of safety devices
22 Lubricate the machine according to overview of lubricating points P. 58
To Next Page
Loading...
