TL260
Operation
114 / 187
7
07_Operation_en.fm - V 0.1 - 14.4.11
15
Adjusting heating, ventilation and air-conditioning
The air-conditioning unit should be switched on for approx. 5 minutes at least
once a month to lubricate the compressor seals.
After switching on the air-conditioning system, open the windows 2-3 minutes
to allow the hot air (stored heat) to escape.
Keep windows and doors closed.
Fig. 7-3 Button assignment of operator control panel Heating, ventilation and air-conditioning
Cooling (10) If the LED below the button lights up (10), cooling is ON. If the LED does not light
up, cooling is OFF.
Circulating air
(9)
If the LED under the button lights up (9), recirculation mode is activated. If the
LED does not light up, fresh air mode is activated.
Display (3) The display (3) shows the relevant temperatures or trouble codes in case of
malfunction.
Fan (4) The LEDs in the fan symbol indicate the momentary fan speed.
Note
It is recommended to cool down the vehicle interior temperature by no more
than 6 to 8°C below outside temperature.
AUTO
OFF
11 10 9 8
3 4
52
1 6
7
4560_5006
To Next Page
