TL260
Maintenance
92 / 187
6
06_Maintenance_en.fm - V 0.1 - 14.4.11
11
Fig. 6-30 Changing the filter insert of the suction filter
Remove the assembly (10) by turning and completely removing the filter
cover, paying attention to the O-ring (3).
Grasp the assembly by the filter cover (1) and unscrew the valve (2).
Remove the filter insert and dispose of according to regulations.
Clean the filter cover with centre rod (8) and the valve with diesel oil or
benzine. While doing so, pay attention to the retaining plate (6) along with the
seals (5), (7) and the compression spring (4).
Check the O-ring (3) and seals (5), (7), (11) and replace any damaged part.
Place surface “A” of the filter cover on a solid base, push a new filter insert
onto the centre rod and fit onto the seal (5).
Push the filter insert downward against the springs and tighten the valve (2)
by hand.
Slide the assembly (10) into the enclosure (12) and tighten the filter cover by
hand. Ensure that the O-ring (3) is in exactly the right position.
Screw back on the filter cover (1) and tighten by hand.
Check the tightness of the filter by means of a test run.
To Next Page
