6 Using the product
118
Designation Explanation
Condition Condition that was fulfilled so that the
alarm was triggered.
4. Click with the right mouse button on the alarm entry that is to be
confirmed and select the Acknowledge command in the context
menu.
- The Acknowledgement dialogue is opened.
5. Mark the entry of the alarm that should be acknowledged.
6. If needed, enter Comments on the alarm in the field of the
same name and confirm the alarm with [OK].
- The symbol shows that the alarm was confirmed and the
comments are carried over in the alarm list in the display range.
The confirmation of the alarm is transmitted to the Saveris base.
As soon as the confirmation is received in the Saveris base, the
alarm relay stops flashing and the alarm is deleted.
Pos: 152 /TD/Produkt verwenden/testo Saveri s/07 Berichte/00 Beri chte erstellen SBE @ 0\mod_119028 0535671_79.doc x @ 5032 @ 2 @ 1
6.7. Creating evaluations
You can print out series of measurements or have reports on the
data automatically created by the software in definable intervals.
Pos: 153 /TD/Produ kt verwenden/testo Sa veris/07 Beric hte/01 Bericht drucken @ 0\ mod_1189522120546_79.doc x @ 4294 @ 3 @ 1
6.7.1. Printing measurement data
Measurement data can be printed in diagram or table form.
1. Select the day or time period in the calendar for which the
report should be created.
- The data for the day or the time period are shown as a diagram
or table, depending on the setting.
> In the Start | View menu, select the
To Next Page
Loading...
Need help?
General
