5 First steps
84
5. Place probe on the wall bracket until it engages.
Please refer to "Removing probe from wall bracket" for
removing the probe from the wall bracket.
Pos: 88 /TD/Erst e Schritte/testo Saver is/07 **** Montage der Hard ware/04 System prüf en @ 0\mod_1191327191562_7 9.docx @ 5362 @ 3 @ 1
5.13.4. Checking the measuring system again
> Perform another test run at the measuring system; see
"Performing the test run".
After mounting the hardware, perform another check of
the system to test the proper function of the measuring
system.
You can thus recognize whether probes are located
outside of the range of the Saveris base, where
applicable, or the radio link is interfered with by
structural conditions.
To Next Page
Loading...
Need help?
General
