TESTO Saveris T1E Ethernet probe User Manual

5 First steps
63
The first two blocks of the IP address must match those
from the Saveris base in this example. The last two
blocks can be selected freely, but must differ from the
Saveris base.
The IP address, the netmask and the gateway can be
read off at the Saveris base in the Info Base menu; see
Displays, page 15.
4. Click on [Continue >].
- The dialogue for the entry of the connection data for the base is
shown.
5. Enter IP address or DNS entry of the Saveris base.
The IP address can be read off at the Saveris base in
the Info Base menu; see Displays, page 15.
You can determine the DNS entry using the label on
the back of your Saveris base.
The DNS entry consists of the word "testo" and the last
six digits of the "MAC address" on the label excluding
spaces and hyphens (e.g. testo00081B).
6. Click on [Finish].
- The Ethernet probe is restarted, synchronized with the Saveris
base and the number of connected Ethernet probes in the
display of the base is increased by 1; see Displays, page 15.
Pos: 75 /TD/Erst e Schritte/testo Saver is/Hardware erwei tern/03 Ethernet-Fühler einbinden/04 Netz werkkabel an Base anschlie ßen @ 1\mod_1203430798656 _79.docx @ 8313 @ 4 @ 1

TESTO Saveris T1E Ethernet probe Specifications

General

Brand	TESTO
Model	Saveris T1E Ethernet probe
Category	Measuring Instruments
Language	English