TESTO Saveris - Integrating Saveris converter (optional)

7 Using the product
72
Create new group
1
Right-click on component, then click on Insert into new group.

A new alarm group is created.
2
Overwrite the default names in Group alarm settings.
Move to…
1
Right-click on component, then click on Move to ....

A selection of available alarm groups is displayed.
2
Click on required alarm group.

The component is assigned to the selected alarm group.
Remove from group
1
Right-click on component, then click on [Remove from group].

The component is removed from the assigned alarm group.
Delete group
1
Right-click on component, then click on [Delete this group].

The assigned alarm group is deleted, all components that were
assigned to this group are now without an alarm group.
Channel alarms
No configuration changes are transferred to the Saveris data
logger/Saveris base until you have exited the Alarm management
menu!
You should therefore exit the Alarm management menu after any
changes.
1
Click on Alarm management in the navigation area.

The following submenus are displayed in the data area:
• Alarm settings base
• Alarm settings component
• Alarm settings channel
• Alarm recipients