3 SPECIFIC SAFETY RULES FOR USING eLIGHT ONE AND
eLIGHT ONE
D
The technology used for the design and manufacturing control of eLIGHT ONE / eLIGHT
ONED makes it a reliable, simple and safe device to use.
The personnel in charge of using the diagnostic and measuring tools is required to follow the
general safety rules and to use the eLIGHT ONE /eLIGHT ONE
D
device for its intended use
only. Furthermore, they are required to carry out the maintenance as described in this
manual.
3.1 Glossary
Operator: a qualified person responsible for using the diagnostic tool.
device: any eLIGHT ONE / eLIGHT ONE
D
device
3.2 General Rules
•
The operator must have basic knowledge of mechanics, automotive engineering, car
repair and of the potential dangers that may arise during self-diagnosis and
measurement operations.
•
The operator must have carefully read all the information and instructions in the technical
documents provided with the tool.
3.3 Operator Safety
The device was designed and built to be stable and solid once installed correctly.
Severe impacts may compromise its stability other than its functionality.
Safety Measures:
•
Move the device only as indicated in this manual.
•
Do not move the device on rough or uneven floors.
•
Avoid moving the device on excessive slopes as much as possible.
The device was designed and built so as to minimise the possibility of crushing
due to moving parts.
Unsuitable clothing for the work environment and carelessness when using the
device may put the operator at risk of injury.
Safety Measures:
•
Use the necessary safety equipment.
•
Always wear appropriate clothing for the work environment.
•
Be careful when adjusting the moving parts of the device.
The base of the device may be an obstacle that could cause you to stumble.
Safety Measures:
58
To Next Page
Loading...
