3.4 Device Safety
The device was designed to be used in the environmental conditions indicated in
the Technical Features chapter.
Using the device in environments with temperatures and humidity that differ from
those specified, may impair its efficiency.
Safety measures:
•
Always place the device in a dry area.
•
Keep the device at a minimum distance of 1 metre from the walls.
•
Do not expose or use the device close to heat sources.
•
Do not use corrosive chemicals, solvents or harsh detergents to clean the device.
The tool was designed to be mechanically tough and suitable for use in a workshop.
Careless use and excessive mechanical strain may impair its efficiency.
Safety measures:
•
Do not drop, shake or knock the device.
•
Do not carry out any type of intervention that may damage the device.
•
Do not open or disassemble the device.
•
The device must be moved on its own wheels only.
•
Adjust the position of the optical box only through the specific handle.
•
Do not use the optical box as a supporting surface.
•
Pay the utmost attention not to damage the Fresnel lens in any way.
The device was manufactured to be electrically safe and to work with specific
supply voltage levels.
Failure to comply with the specifications related to the power supply may impair
the device's efficiency.
Safety measures:
•
Do not wet the device with water or other liquids.
•
The device's power supply must always be connected following the indications provided
in this manual.
•
Do not use an external batteries to supply the device.
The electromagnetic compatibility tests carried out on the device guarantee that it
can be adapted to the technologies normally used on vehicles (ex.: engine control,
ABS, etc.). Nevertheless, if malfunctions occur, contact the vehicle's dealer.
60
To Next Page
Loading...
