Texas Instruments Jacinto7 J721E - 3.2 Power ON Switch and Power LEDs

ON
EVM User Setup/Configuration www.ti.com
14
SPRUIS4A–December 2019–Revised May 2020
Submit Documentation Feedback
Copyright © 2019–2020, Texas Instruments Incorporated
Jacinto7 J721E/DRA829/TDA4VM Evaluation Module (EVM)
3.2 Power ON Switch and Power LEDs
The power to the EVM is controlled by the power ON/OFF switch (SW2) on the CPB. To turn the board
ON, slide the switch in the direction as shown in Figure 9 .
Figure 9. Power ON/OFF Switch