Texas Instruments Jacinto7 J721E - 3.6 JTAG Emulation

MUX
2:1
(x2)
R
A
S
B2
B1
JTAG_MUX_SEL
VCC_3V3_XDS
SOC_TDI,
SOC_TMS
SOC_TMK,
SOC_TRST#,
SOC_TDO
SOC_EMU0
SOC_EMU1
EXT_MIPI_TDI,
EXT_MIPI_TMS,
EXT_MIPI_TCK,
EXT_MIPI_TRST
EXT_MIPI_TDO,
EXT_MIPI_EMU0,
EXT_MIPI_EMU1
(ExternalJTAG)
XDS110_TDI,
XDS110_TMS,
XDS110_TCK,
XDS110_TRST
XDS110_TDO,
XDS110_EMU0,
XDS110_EMU1
(OnboardJTAG)
EVM User Setup/Configuration www.ti.com
24
SPRUIS4A–December 2019–Revised May 2020
Submit Documentation Feedback
Copyright © 2019–2020, Texas Instruments Incorporated
Jacinto7 J721E/DRA829/TDA4VM Evaluation Module (EVM)
3.6 JTAG Emulation
The Common processor board includes XDS110 class on board emulation through the micro B connector
J3. It also has an option to support external emulation through MIPI 60 pin header (J16). When an
external emulator is connected, XDS110 emulation circuitry path will be disconnected automatically.
Figure 15. JTAG Mux
Table 12. JTAG 1:2 Mux selection
Condition MUX_SEL Function
XDS110 Powered via USB HIGH A<->B2 port [On Board EMU]
External Emulator attached LOW A<->B1 port [EXTERNAL EMU]