Textron Cessna 182S - Page 161

CESSNA
AIRCRAFT
COMPANY
MODEL
182/T182
WIRING
DIAGRAM MANUAL
A3990
1. Drop
either the
pin or socket
contact
to be crimped
into the crimping
tool with the contact
crimp barrel
facing
up. This
tool features
a universal
crimp
stop
which is interchangeable
with
pins and
sockets.
2. Insert
the bare
wire into the
open end
of the contact
and squeeze the
crimp tool. (The crimp
tool will only
release the contact
when the full-crimping
cycle has
been
performed.)
Remove
the crimped
contact
from
the tool.
3. Visibility
of the
wire in the
contact inspection
hole
(arrow) indicates that
the wire is crimped
into the
contact at the proper
depth and dimension.
TO INSERT
1. Hold
the colored
half of
the appropriate
insertion/
removal
tool
between the
thumb and
forefinger
and
lay the
wire to be
inserted along
the slot
leaving
about
0.50 inch
of wire protruding.
Then snap
the
wire into
the tool. (Size 8 contacts
do not require
a
tool.)
55802010
Typical Removal
and Installation of Rear-Release
Contacts
Figure
204
(Sheet 1)
© Cessna
Aircraft
Company
20-10-04
Page 211
Feb 13/2006