Textron Cessna 182S - Page 165

CESSNA AIRCRAFT COMPANY
MODEL 182/T182
WIRING DIAGRAM MANUAL
A4016
CONTACT INSERTION
5. Remove hardware from plug and
receptacle.
Slide
hardware over
wire
bundle in proper
order for reassembly.
6. Use the proper contact insertion tool,
and slide the tool over the terminal
end of the contact. The size 16 contact
lies in the
tool and the
tool tip butts
against the contact shoulder. The rear,
or
insulation support
of the size
20
contact butts against an internal
shoulder in the tool tip.
ENDBELL
RULE
NG NUT
BARREL
NUMBER 16 CONTACTS
TOOL
NUMBER 20 CONTACTS
7. Beginning from center cavity and working
outward, insert
wired contacts into
rear
of connector by hand until the front of the
contact shoulder is no more than 0.12 inch
from the grommet. Holding the connector
securely, position tool behind contact.
Push tool straight into contact cavity until
contact
snaps into position.
A light pull
on
the wire will assure that contact is locked
securely.
Repeat for remaining
contacts.
8. Use wire hole fillers or grommet sealing
plugs to fill any empty cavities and
assemble
hardware
to rear of plug or
receptacle.
55801008
55801009
55801008
Typical Removal and Installation of Front-Release Contacts
Figure 205 (Sheet 2)
20-10-04
Page 215
Cessna
Aircraft Company
Feb 13/2006