Textron Cessna 182S - Page 166

CESSNA AIRCRAFT
COMPANY
MODEL 182/T182
WIRING
DIAGRAM
MANUAL
A4021
COMPLETION
9.
Check
face of plug
or receptacle
for
proper
contact
installation.
CONTACT
EXTRACTION
10.
Slide
hardware
back
over
wire
bundle.
Using
proper
extraction
tool or
extraction
end of
proper
insertion/extraction
tool,
proceed
as follows:
KPTM:
Make
sure reversible
tool tip
is
set
for pin
or
socket
contacts.
Place
tool
tip
over contact
from
front of insulator
and,
with slow
and even
pressure,
push
contact
out
of back of
insulator.
MS3126F-xx-xxx:
Use
the
proper
extraction
tool.
There are
two lines
on the
clip sleeve
which are vital
to the contact
removal
process.
The
first index
line
is
used
for
removing
pin
contacts
while the
second
index
line is
for removing
socket
contacts.
Carefully
place
the tool
over the
contact
to be
extracted
until
the tool
tip
touches
the
insulator
face.
Carefully
rotate
the
tool
until the
index line
is slightly
below
the
insulator
face.
Keep
an
even
pressure
against
tool
body;
push
plunger
forward
with thumb
and
index
finger, and
push
the
contact
out
through
the
clip.
Carefully
remove
extraction
tool
from connector.
Pull
the
wire
by hand
to
complete
the
removal of the contact.
FIRST INDEX LINE
PIN CONTACTS
SECOND
INDEX
LINE
SOCKET CONTACTS
55801008
55801009
55801008
Typical
Removal
and Installation
of Front-Release
Contacts
Figure
205 (Sheet
3)
© Cessna
Aircraft
Company
20-10-04
Page
216
Feb 13/2006
]