EX-TRAFIRE
®
105HD 5 Transport and positioning
17
5 Transport and positioning
Risk of injury due to improper transport and installation
Improper transport and installation can cause the power supply to tip or
fall over. This may result in serious injury.
Wear your personal protective equipment.
Ensure that all supply lines and cables do not encroach into the area in
which employees are working.
Place the power supply on a suitable surface (flat, solid, and dry) on
which it will not topple over, taking into account the max. operating tilt
angle of 15°.
Note the weight of the power supply when lifting it. Lift with two
persons.
4.2 Technical data on page 12
Use an appropriate lifting tool with load handling equipment for
transporting and installing the power supply.
Avoid abrupt lifting and setting down.
Do not lift the power supply over individuals or other devices.
Use the attachment points provided.
Risk of material damage due to improper transport and installation
Improper transport or installation can cause the power supply to tip or
fall over. This can result in material damage and irreparable damage.
Protect the power supply against weather conditions, such as rain and
direct sunlight.
Protect the power supply from spatter when cutting.
Protect the power supply from direct exposure to sparks when
grinding.
Use the power supply only in dry, clean, and well-ventilated rooms.
Maintain a minimum distance of 3.3 ft (1 m) from the wall when
positioning the power supply to ensure that it has sufficient ventilation.
Fig. 6 Drain tube location
When positioning the power supply,
make sure that the water separator's
drain opening (see circle) is not
covered.
To Next Page
