EX-TRAFIRE
®
105HD 2 Safety
7
2 Safety
This chapter warns of potential hazards that should be kept in mind to
operate the product safely. Non-observance of the safety instructions may
result in risks to the life and health of personnel, environmental damage, or
material damage.
2.1 Designated use
The power supply may be used only for the purpose and manner
described. The power supply is used only for the generation and control of
the output current required for plasma cutting, gouging, and marking. Any
other use is considered improper. Unauthorized modifications or changes
to enhance the performance are not permitted.
Do not exceed the maximum electrical load specifications as defined by
the document supplied. Overloads could lead to destruction.
Do not make any modifications or changes to this product.
Do not use the power supply to thaw pipes.
Do not use or store the power supply in wet conditions or
environments.
2.2 Obligations of the operator
Ensure that only qualified and trained personnel are permitted to work
on the power supply.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational
safety and accident prevention;
— those who have been instructed on how to handle the power supply;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their
special training, knowledge and experience.
Keep untrained persons out of the work area.
The EX-TRAFIRE
®
105HD can produce electromagnetic fields that could
impact the proper function of cardiac pacemakers and implanted
defibrillators.
Do not use the EX-TRAFIRE
®
105HD if you have a pacemaker or an
implanted defibrillator.
To Next Page
Loading...
