THERMACUT EX-TRAFIRE 105HD - Default Chapter; Table of Contents

2
EX-TRAFIRE
®
105HD
Table of contents
1 Identification............................................................................5
1.1 Labeling..................................................................................................5
1.2 Identification plate ................................................................................5
1.3 Signs and symbols used.......................................................................6
1.4 Classification of the warnings ..............................................................6
2 Safety .......................................................................................7
2.1 Designated use......................................................................................7
2.2 Obligations of the operator .................................................................7
2.3 Warning and notice signs.....................................................................8
2.4 Product-specific safety instructions.....................................................8
2.5 Safety instructions for the electrical power supply ...........................8
2.6 Safety instructions for plasma cutting.................................................9
2.7 Personal protective equipment ...........................................................9
2.8 Emergency information........................................................................9
3 Scope of delivery ...................................................................10
4 Product description ................................................................11
4.1 Assembly and use ...............................................................................11
4.2 Technical data......................................................................................12
4.3 Technical data for cutting torches FHT-EX
®
105TTH and
FHT-EX
®
105TTM..................................................................................14
4.3.1 Torch dimensions FHT-EX
®
105TTH...................................................16
4.3.2 Torch dimensions FHT-EX
®
105TTM ..................................................16
4.3.3 Torch dimensions FHT-EX
®
105TTSM................................................16
5 Transport and positioning ......................................................17
6 Setting up the power supply..................................................18
6.1 Connecting to the gas supply............................................................18
6.2 Connecting the work lead..................................................................18
6.3 Connecting the power supply cable ................................................18
6.3.1 Connecting the single-phase machine.............................................18
6.3.2 Connecting the three-phase machine..............................................19
6.4 Connecting the input power plug.....................................................19
6.4.1 Connection to a generator (optional)...............................................20
6.5 Connecting the cutting torch.............................................................21
6.5.1 Installing the cutting torch's gear rack .............................................22
6.6 Installing consumables for the hand and machine
cutting torches.....................................................................................23
6.7 Aligning FHT-EX
®
105TTM machine cutting torch...........................25
7 Operation of the power supply..............................................25
7.1 LCD description...................................................................................26
7.1.1 Setting the parameters .......................................................................27
7.1.2 Selecting the cutting mode................................................................27
7.1.3 Connecting the work lead..................................................................28
7.2 Powering on the machine ..................................................................28
7.3 Manual cutting process ......................................................................29
7.4 Manual grid cutting and gouging process ......................................29
7.5 Cutting – Edge Start ............................................................................30