THERMACUT EX-TRAFIRE 105HD - Stopping the Cutting Process; CAUTION: Risk of Injury Due to Hot Parts; Decommissioning

EX-TRAFIRE
®
105HD 8 Decommissioning
33
7.8 Stopping the cutting process
 Release the torch trigger to end the cutting process.
After releasing the torch trigger, the gas continues to flow for up to
25 seconds in order to cool the cutting torch and the consumables.
 To end the gas post-flow period prematurely, briefly press and release
the torch trigger.
 Press the torch trigger again to ignite the pilot arc.
8 Decommissioning
1 Set the POWER switch to OFF.
2 Disconnect the EX-TRAFIRE
®
105HD from the input power supply.
3 Disconnect the EX-TRAFIRE
®
105HD from the gas supply.
4 Apply inward pressure to TCS plug when lifting latch for leads removal.
CAUTION
Risk of injury due to hot parts
Parts may still be hot after the gas post-flow period ends. There is a risk of
burns.
 Wear your personal protective equipment.
 Allow the cutting torch to cool down for 5 to 10 minutes before
touching the parts.