14
2.4 LIFTING THE POWER SUPPLY
INSTALLATION
Figure 2-G Lifting the Power Supply
CAUTION
Do not lift a power supply equipped with a cylinder rack
running gear.
The recommended method for lifting the power supply is
to use a forklift (see Figure 2-G). Approach from either
side of the unit. Lifting from the front or rear may damage
protruding fittings. Place the forks between the rear wheel
and the front caster. Center the forks under the unit and
carefully check for proper balance.
WARNING
Do not lift the power supply by the handle.
To Next Page
Loading...
