www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
1.Turn off the whole machine power.
2.Take out the belt by taking down the motor.
Loosen three screws A firstly.
Adjust screw B anticlockwise to loosen the belt by taking down the motor.
Then take out the belt from the motor.
3.Loosen the four screws in the bottom of this unit as below:
Push the X Axis front and back by hand, will find that the noise is disappear.
This is the most important step to screw them back, cause fix the screws not good ,it will make
noisy again.
To Next Page
Loading...
