www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel : (86)769 826653 Dongguan City, Guangdong Province, China
①Fasten the outward two screws first, please do it carefully, screw them a little then check the
sounds by pushing the X Axis, screw them little by little until tighten them enough. Loosen them
and repeat step ① again if the couplings make the large noise again.
② After it’s ok of the sounds by fastening the outward two screws. Then fix the rest of screws in
the bottom.
③Adjust back the belt.
How to adjust the belt of Motor:
Loosen three screws A firstly.
Adjust screw B clockwise to tighten the belt; Adjust screw B anticlockwise to loosen the belt.
The belt tension should be same with the belt X motor.
After that, fasten the three screws A.
PS：A small noise is ok no affect the process results, it’s hard to make the noise disappear fully by
non-professionals.
End
To Next Page
Loading...
